Hi,
I have recently upgraded my project from Silverlight 4 to Silverlight 5. I was using Infragistics 2011 vol 1 previously which I've uninstalled and installed 2012 vol 2. The project was not giving any compilation/run-time error before up-gradation. During upgrade process I didn't change any XAML or C# source code, but simply changed Infragistics dll references. When I executed the project, I see following exception. I could not find the exact location of exception in debugging mode.
Could someone please help me in this?
Hello Rohan,
Thank you for your post. I have been looking into it but since this is not a known issue, I am not able to conclude what can cause such behavior, so could you please send an isolated sample project, where the issue is reproduced, so I can investigate it further for you.
Looking forward for your reply.
Hi Stefan,
Thanks for your reply...
When I was using Infragistics 2011 version, there used to be "InfragisticsSL4.Controls.Editors.v11.2" dll reference in my project. Now, in 2012 vol 2, I could not find that dll to refer to. Could you please guide me on this? I don't know if that has caused any problem or not, I'm simply trying to find out the possibility...
Thanks and Regards,
Rohan
This assembly is not required for the XamRibbon and the exception you have is related to the QuickAccessToolbar. In order to have more details about the exception I can suggest you enable the Common Language Runtime Exceptions by opening Debug -> Exceptions… -> and tick the Common Language Runtime Exceptions by opening Debug. After doing that you will be able to get more information about the exception.
As per your suggestion, I enabled Common Language Runtime Exceptions and what I observed is attached.
Thanks & Regards,
I have been looking into the message you attached, but I am still not able to conclude what can casue this behavior. If you could send me an isolated sample project where this is reproduced I will be able to investigate this further for you.